Memorex MLT1912 User Manual download pdf (Page 11)

VCR CONNECTIONS

CONNECTION USING COAXIAL CABLE:

Follow the instructions below to connect a VCR to your television using a 75 ohm coaxial cable. (CABLES NOT INCLUDED.)

1. Connect the cable, satellite or incoming antenna to the VHF/UHF IN jack on the rear of the VCR.

2. Connect a 75 ohm coaxial cable from the VCR’s 75 Ohm OUT jack to the Antenna IN jack on the side of the TV.

3. Press the SOURCE button until “TV” appears on the TV screen and press PLAY on the VCR to watch a tape.

VCR

NCOMING CATV CABLE

From VCR OUT jack

1. Connect the cable, satellite or incoming

antenna to the VHF/UHF IN jack on the

rear of the VCR.

2. Connect the left and right audio cable from

the VCR’s AUDIO OUT jacks to the TV’s

left and right

AUDIO IN jacks. Connect the

VCR’s VIDEO OUT jack to the TV’s VIDEO

IN jack.

3. Press the SOURCE button until AV

appears on the TV screen and press PLAY

on the VCR to watch a tape.

NOTE: Side panel is accessible by pressing in

on the tabs, then lift the side cover off. After

connections have been made, slide the wires

through the bottom opening of the cover and

replace cover.

CONNECTION USING AUDIO/VIDEO CABLES:

Follow the instructions below to connect a VCR to your television using Audio/Video cables. (CABLES NOT INCLUDED.)

AQ:

My VCR has only 1 Audio jack, but this TV has two Audio input jacks, how do I connect it?

Simply connect it to the “L (Mono)” Audio input jack, but the sound will be monaural.

Side panel is accessible by pressing in on the tabs, then

lift the side cover off. After connections have been

made, slide the wires through the bottom opening of the

cover and replace cover.

Jack panel is shown on

its side. Top of panel is

this side.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 81 82

No comments

Memorex MLT1912 User Manual Page 11